Multi abutments for immediate screw-retained prostheses are mounted on the implants, and the screws have been concealed with a plastic rod for quick removal.

Solidify the impression transfers: make a dead turn on the distal most right impression transfer by holding it with a clamp and light cure. Then unwind the braid with D-Lab CST LINK™ under tension (press the snap button) to progress to the distal-most left implant, with each abutment locked by a dead turn.

The whole is polymerised with blue light Solidify the impression transfers: make a dead turn on the distal most right impression transfer by holding it with a clamp and light cure. Then unwind the braid with D-Lab CST LINK™ under tension (press the snap button) to progress to the distal-most left implant, with each abutment locked by a dead turn.

To complete the bonding of the structure, a small amount of CST LINK™ resin is applied to each abutment and light cured with blue light.

A translucent membrane impression tray is filled with a transparent silicone and inserted onto the preparations. During setting (2 min), light curing is completed by illumination through the translucent silicone.

A translucent membrane impression tray is filled with a transparent silicone and inserted over the preparations. During the setting time (2 min), light curing is completed by illumination through the translucent silicone.

The print is detected and sent Solidify the impression transfers: make a dead turn on the distal most right impression transfer by holding it with a clamp and light cure. Then unwind the braid with D-Lab CST LINK™ under tension (press the snap button) to progress to the distal-most left implant, with each abutment locked by a dead turn.

The impression is cast in the laboratory with perfect repositioning of the implant analogues. Then a prosthesis is made directly with the Fiber Force CST